Please follow the steps shared below for P400 Configuration --
On the initial screen
As the PED reboots for the first time- the screen will prompt for a password- The password is 2345 and should be entered to configure comms method- in case this steps is missed- the PED will keep prompting for the initial screen password until a comms method has been selected.
P400 Comms method change through Engineering Menu
1. On the P400 - Enter Engineering mode (1 and Enter or 1 and clear)
2. Enter Password (default SE915074)
3. Enter into Comms setup > Comms type
4. Select communication type (USB/TCPIP/eth/Serial)
5. Press the ‘Red’ button on the PED to go back to the home-screen.
Was this article helpful?
That’s Great!
Thank you for your feedback
Sorry! We couldn't be helpful
Thank you for your feedback
Feedback sent
We appreciate your effort and will try to fix the article